Wade's CG-16N 124' Commercial Guyed tower is packaged complete with (16) 8' sections, a top and rotor plate with model 244A mast clamp installed, 6 guy stations, concrete base stubs, and our special nuts, bolts and washers.  Wade's Commercial Guyed towers are ideal for supporting communications, civil and amateur antennas.

Features:

• Enhanced in both leg profile and taper facilitating an easier installation and improved tower structure.
• 8 foot tower sections.
• Twist-reducing beaded-channel legs riveted together with "X" braces.
• Legs and cross braces are galvanized steel.
• Rivets are solid aluminum, anodized.
• Special nuts and bolts are 1/2" O.D. and heat treated.
• Straight sections fit smoothly together, since all leg bottoms are accurately swaged for a perfect fit.
• Special three-size guy stations are strong and reliable. They are attached every three sections from the base up (except for CG-19N) and at the top of the tower.
• Designed to withhold impact load of a climber in case of a fall in accordance with CSA-S37-13. See installation instructions for more information.*

LOAD LIMITS:  Towers are designed to support a net antenna weight of up to 80 lbs. with a horizontal wind load of up to 300 lbs. plus rotor and 2” O.D. x 10 ft. mast.**

NOTE:  Never install a tower or tower section found to have missing or damaged components. Only Wade replacement components or hardware may be used on DMX products. Failure to exercise this caution can result in injury or death. Consult distributors for replacement sections or parts if required.

* Towers have not been tested to be in compliance with other sections of CSA-S37-13.

** Tower load limits are based on survival, and cannot be stamped by a licensed engineer.